Projecting

To turn off the power

1 Press the I / 1 key.

“Power OFF?” appears on the screen.

Note

The message will disappear if you press any key except the I / 1 key, or if you do not press any key for five seconds.

2 Press the I / 1 key again.

The ON/STANDBY indicator flashes in green and the fan continues to run for about 120 seconds to reduce the internal heat. Also, the ON/STANDBY indicator flashes quickly for the first 40 seconds. During this time, you will not be able to turn the power back on with the I / 1 key.

3 Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red.

When you cannot confirm the on-screen message

When you cannot confirm the on-screen message in a certain condition, you can turn off the power by holding the I / 1 key for about one second.

Note

Do not unplug the AC power cord while the fan is still running; otherwise, the fan will stop although the internal heat is still high, leading to breakdown of the projector.

About the air filter cleaning

Clean the air filter every 300 hours to ensure

optimal performance.

To enlarge the image (Digital Zoom function)

You can enlage the point on the image you select. This function works only when a signal from a computer (except for UXGA) is input.

1 Press the D ZOOM + key on the Remote Commander.

The Digital Zoom icon appears in the center of the image.

Digital Zoom icon

2 Move the icon to the point on the image you want to enlarge. Use the arrow keys (M/m/</,) to move the icon.

3 Press the D ZOOM + key again.

The image where the icon is located is enlarged. The enlargement ratio is displayed on the screen for a few seconds.

By pressing the + key repeatedly, the image size increases. (ratio of enlargement: max. 4 times)

Use the arrow keys (M/m/</,) to scroll the enlarged image.

To return the image back to its original size

Press the D ZOOM – key. Just pressing the RESET key returns the image back to its original size immediately.

To freeze the image projected (Freeze function)

Press the FREEZE key. “FREEZE” appears when the key is pressed. This function works only when a signal from a computer (except for UXGA) is input. To restore the original screen, press the FREEZE key again.

To use the Laser Pointer function

Press the LASER key on the Remote Commander. The laser pointer appears. The pointer is helpful in indicating a particular point on the screen.

20 (GB)