4 Press the FOCUS key then the Mor m key on the Remote Commander to adjust the focus.
“LENS FOCUS” appears on the screen during adjustment.
5 Press the ZOOM key then the Mor mkey on the Remote Commander to adjust the picture size.
“LENS ZOOM” appears on the screen during adjustment.
6 Press the FOCUS key and arrow keys on the Remote Commander to adjust the focus again.
7 Press the SHIFT key then the Mor mkey on the Remote Commander to adjust the vertical position of the picture.
“LENS SHIFT” appears on the screen during adjustment.
Note on focus and zoom adjustments
If the optional VPLL-ZM101,VPLL-ZM31 or VPLL- FM21 lens is installed, perform the focus and zoom adjustments manually.
To use the keys on the control panel for focus, zoom and shift adjustments
Press the LENS CONTROL key repeatedly to display the adjustment mode you want. Each press changes the mode, “LENS FOCUS,” “LENS ZOOM” and “LENS SHIFT” in this order. Then press the arrow keys to adjust.
Note
Looking into the lens when projecting may cause injury to your eyes.
Cut off the picture
Press the PIC MUTING key on the Remote Commander. To restore the picture, press the PIC MUTING key again.

INPUT-A:Selects video signal input from the INPUT A connector.

INPUT-B:Selects video signal input from the INPUT B connector.

INPUT-C:Selects to display the Windows CE window.

VIDEO: Selects video signal input from the VIDEO (VIDEO IN) jack.

S-VIDEO:Selects video signal input from the S VIDEO (VIDEO IN) jack.

Projecting

To get the clearest picture

You can get the suitable picture when a signal from the computer is input. Press the APA key.

The picture is automatically adjusted to be projected clearest.

Notes

•Adjust the signal when the still picture is displayed on the screen.

•Press the APA key when the full image is displayed on the screen. If there are black edges around the image, the APA function will not function properly and the image may extend beyond the screen.

•If you switch the input signal or re-connect a computer, press the APA key again to get the suitable picture.

•“ADJUSTING” appears on the screen. To restore the original screen, press the APA key again during the adjustment.

•“Complete!” appears on the screen when the picture is adjusted properly. The picture may not be adjusted properly depending on the kinds of input signals.

•Adjust the items in the INPUT SETTING menu when you adjust the picture manually.

For details, see page 23 (GB).

To correct the trapezoid

When the projecting image is a trapezoid, perform the shift adjustment with the SHIFT key.

If the image is still a trapezoid, correct it in DIGIT KEYSTONE in the INSTALL SETTING menu.

When the base edge is longer than the upper edge as shown in the figure below:

Set the value to negative.

When the upper edge is longer than the base edge as shown in the figure below:

Set the value to positive.

For details on “DIGIT KEYSTONE,” see page 27 (GB).

19 (GB)