5 Lift and remove the lens.
6 Using a Philips screwdriver, remove the four screws (M3⋅ 6, black) holding the left and right spacers as shown in the diagram, and then remove the spacers.
Note
The spacer and the screws may be needed later on. Store them.
7 Remove the two screws (M3⋅ 8, silver) from the section in the figure, and then remove the lens bottom cover.
8 Lift up and tilt the left side of the lens bottom cover, bring it toward the right side, and then remove it in the right upward direction while keeping it tilted.
9 Align the positions so that the stopper for the lens is in contact with the stopper of the projector unit, and then attach the lens.
Stopper (Projector)
Stopper
(Lens)Stopper
(Projector)
Stopper (Lens)
Note
For ease in identification when you install the lens, make sure that the lens stopper is facing up.
10 Using a Philips screwdriver, tighten the four screws (M3⋅ 10, with washers) that secure the lens in place.
11 Use the two screws (M3⋅ 8, silver) to mount the removed lens bottom cover over the lens in the orientation shown in the figure below.
15