iOUTPUT (audio output) connector (3.5-mm diameter stereo mini jack)

Connect one end of the supplied XLR-BMP conversion output cable for the URX-P2 or the stereo mini plug-BMP conversion cable here and the other end to the microphone input on a camcorder, mixer, or amplifier. If the microphone input connector on the device connected to the tuner is a stereo mini jack, connect the straight (BMP) plug to the tuner and the L-shaped (stereo mini) plug to the microphone input connector on the device.

Note

To prevent damaging the tuner, do not apply power voltage to this connector through the connection to external devices.

Diversity tuner module (URX-M2)

aSET button

Press to change and enter display parameters.

For details, see “Tuner Settings” on page 50.

bRF (radio frequency) indicator The color indicates the strength of the RF

input signal.

On (green): RF input is 25 dBµ1) or more.

Off: RF input is less than 25 dBµ1).

1) 0 dBµ = 1 µVEMF

cDisplay section

The channel indication (C) for U30 model is shown.

ARF (radio frequency) indications The number of dots indicates the RF input level.

BAF (audio frequency) indication Appears whenever the output audio signal is stronger than the reference level.

CGP (group)/CH (channel) indication Shows the reception channel group and channel number. Each time you press the SET button, the channel indication changes as follows.

For details, see“Tuner Settings” on page 50.

Reception

 

channel group

Press

and number

the

 

Reception

SET

button.

frequency

 

The channel/frequency indications for U30 model are shown.

d+ (+ selection) / – (– selection/reset) buttons

Press these buttons to set the reception channel and frequency.

Parts Identification

41