Microphone System Frequency List” (for AU66 and E models).

Pressing the – button cycles the indications in the opposite direction. Hold down the + or – button to change the channel number (or frequency) faster.

Notes on the European model

Select the group number before selecting the channel number as follows.

1)While the left two digits are flashing, select the group number by pressing the + or – button.

2)While the desired group number appears, press the SET button. The right four digits start to flash to allow the selection of the channel number.

3)Select the channel number by pressing the + or – button.

Group

Channel

Frequency

selection

selection

selection

V: + button

v: – button

Group, channel, and frequency selection examples for CE62 model are shown.

4 When the desired channel number (or frequency) appears, set the POWER switch to OFF to complete the setting, or press the SET button to set other items.

The results are stored in memory. The stored channel number (or frequency) will appear in the display section the

next time you turn on the transmitter by setting the POWER switch to ON.

Notes

•When you are setting the transmission channel, the transmitter cannot be used to transmit signals.

•Do not remove the batteries while setting the transmission channel. If they are inadvertently removed, re-insert them immediately and redo the procedure “Setting the transmission channel” from step 1.

•Make sure that the selected channel is the same on the transmitter and tuner being used in the same system.

•If you turn off the transmitter and then immediately turn it on right after setting the transmission channel, the unit may not operate normally. Wait a few seconds before turning it on again.

Setting the RF output power level

The procedure below can be performed with the body-pack transmitter (UTX-B2) and the hand- held microphone (UTX-H2).

For U30/U42/CE62/CE67/AU66 models: The RF power output level can be set at 30 mW (“H”) or 5 mW (“L”).

For E model:

The RF power output level can be set at 10 mW (“H”) or 2 mW (“L”).

You can select the RF output power level from “H” or “L” in setting mode. Set the RF output level to “L” for simultaneous operation of multiple channels, and set it to “H” for long-distance operation.

1 Turn on the transmitter while pressing down the SET button.

Transmitter Settings

55