4 When the desired frequency appears, leave the tuner for about 10 seconds or press down the SET button for more than one second.

The selected channel number stops flashing and the selection is stored in memory.

Notes

•Even when you are setting the reception channel, the tuner can be used to receive signals.

•Do not remove the batteries while setting the reception channel. If they are inadvertently removed, re-insert them immediately and redo the procedure “Setting the reception channel” from step 1.

•Make sure that the selected channel is the same on the transmitter and tuner being used in the same system.

•If you turn off the tuner and then immediately turn it on right after setting the reception channel, the unit may not operate normally. Wait a few seconds before turning it on again.

Searching the available channels within the group (Clear Channel Scan)

The procedure below can be performed with the portable diversity tuner (URX-P2) only.

Available channels within the specified channel group can be searched.Before performing this procedure, select the channel group.

For details on channel group selection, see “Setting the reception channel” on page 50.

1 While pressing down the SET button, press the + button.
Keep both buttons pressed down.

2 Release the SET button and the + button after “SCAN +” appears and starts flashing.

3 Press the + button.

The tuner starts to scan through the selected channel group. When available channels are found, the first channel number among the available channels flashes in the display.

To display the next available channel numberPress the + button.To cancel searchingPress the – button. The display shows the flashing “SCAN +” again.To re-select the channel group

Press the SET button again to display the flashing channel group indication, then select the channel group. And then, start from step 1.

4 While the desired channel number is flashing, leave the tuner for about 10 seconds or press down the SET button for more than one second.

Search finishes. The selected channel number stops flashing and the selection is stored in memory.

To start searching while performing settings

While the display section parameters are flashing, press the SET button repeatedly

52 Tuner Settings