Getting Started

The Setup Display for the Control for HDMI function appears.

HDMI SETUP

HDMI RESOLUTION:

AUTO(1920x1080p)

CONTROL FOR HDMI:

OFF

VOLUME LIMIT:

OFF

YCBCR/RGB(HDMI):

ON

AUDIO(HDMI):

OFF

JPEG RESOLUTION:

SD

8 Press X/x to select the setting, then press .

•[OFF]: The Control for HDMI function is set to off.

•[ON]: The Control for HDMI function (page 54) is set to on.

The Setup Display for selecting the speaker formation appears.

SPEAKER FORMATION

STANDARD

9 Press C/c to select the speaker formation image as the speakers are actually positioned, then press .

For details, see “Getting Optimal Surround Sound for a Room” (page 69).

10 Connect the calibration mic (supplied)to the A.CAL MIC jack on the front panel.

Set up the calibration mic at ear level using a tripod, etc. (not supplied).

The front of each speaker should face the calibration mic, and there should be no obstruction between the speakers and the calibration mic.

Calibration mic

11 Press C/c to select [YES], then press

.

[AUTO CALIBRATION] starts. Be quiet during the measurement.

Note

•Loud test sounds are output when [AUTO CALIBRATION] starts. You cannot turn the volume down. Give consideration to children and neighbors.

•The environment of the room in which the system is installed may affect measurements. When the measurements differ considerably from the status of the speaker installation, perform the speaker settings manually by following “Settings for the speakers” (page 48).

12 Unplug the calibration mic, press C/c to select [YES], then press .

Quick Setup is finished. All connections and setup operations are complete.

To quit the Quick Setup

Press DISPLAY in any Step.

22GB