Calibrating the

Appropriate Settings

Automatically

[AUTO CALIBRATION]

D. C. A. C. (Digital Cinema Auto Calibration) can set the appropriate surround sound automatically.

Note

•The system outputs a loud test sound when [AUTO CALIBRATION] starts. You cannot turn the volume down. Give consideration to children and neighbors.

1 Press FUNCTION +/– repeatedly until

“DVD” appears in the front panel display.

2 Press DISPLAY while the system is in stop mode.

The Control Menu display appears on the TV screen.

3 Press X/x to select [SETUP], then press .

The options for [SETUP] appear.

4 Press X/x to select [CUSTOM], then press .

The Setup Display appears.

5 Press X/x to select [AUDIO SETUP], then press .

The options for [AUDIO SETUP] appear.

6 Press X/x to select [AUTO

CALIBRATION], then press .

The options for [AUTO CALIBRATION] appear.

7 Connect the calibration mic (supplied)

to the A.CAL MIC jack on the front panel.

Set up the calibration mic at ear level using a tripod, etc. (not supplied).

The front of each speaker should face the calibration mic, and there should be no obstruction between the speakers and the calibration mic.

Calibration mic

8 Press C/c to select [YES].

9 Press .

[AUTO CALIBRATION] starts. Be quiet during the measurement.

Note

•The environment of the room in which the system is installed may affect measurements. When the measurements differ considerably from the status of the speaker installation, perform the speaker settings manually by following “Settings for the speakers” (page 48).

10 Press C/c to select [YES] or [NO], then press .

xThe measurement is OK.

Disconnect the calibration mic, then select [YES]. The result is implemented.

When you want to cancel the measurement and retry [AUTO CALIBRATION], select [NO].

xThe measurement is not OK.

Follow the message, then select [YES] to retry.

70GB