
Mfg. Since 9/11 | I N S T R U C T I O N S | Model SB1263 |
17.Snug the slide block set screw until the brass plug is slightly
!
Figure 14. Slide block set screw adjustment.
18.Replace the attachment body top cover.
19.Loosen the two cap screws on top of the deadman clamp (see Figure 15), then slide the clamp onto the rear bedway from the tailstock end.
Cap Screws
Arm
20.Thread the arm clevis into the taper attachment, then position the deadman clamp so the end of the arm slides into the arm clamp, as shown in Figure 16.
Note: Do not tighten the arm clamp cap screw or the arm clevis hex nut at this time.
Deadman Clamp
Cap Screws
Arm
Clevis
Arm Clamp
Figure 16. Deadman clamp and arm.
21.Position the deadman clamp towards the end of the arm, then tighten the deadman clamp cap screws to secure the assembly to the bedway.
22.Loosen the dovetail cap screws at each end of the taper attachment body (see Figure 17).
Clamp
Clamping
Plate
Figure 15. Deadman clamp.
Rear
Angle Scale
Dovetail Cap
Screw (1 of 2)
Adjustment Knob
Figure 17. Taper adjustment knob and controls.
23.Turn the taper adjustment knob to bring the dovetail to zero on both scales.