Southwestern Bell GH3210 owner manual Intercom, Call Transfer CALLTRANSFER, Memory Feature

TELEPHONE OPERATION (CONT.)

Intercom

INTERCOM

set will change from “TALK” to “TRANS- FER H1>H2” or “TRANSFER H2>H1”. Likewise, from Stand-by to “CALL TRANSFER” at the transferred handset.)

1.Press INT/TRAN button while in Stand- by mode.

2.The LCD display of the other handset will show “INTERCOM” with a beep sound.

3.Press INT/TRAN (or TALK) button from the called handset to establish intercom between handsets.

4.Press INT/TRAN (or TALK) button from either one of the handset to terminate the Intercom. Both of the handsets will go to Stand-by mode.

NOTE:

If there is no response from the called handset within 30 seconds, the calling handset goes back to Stand-by mode.

Call Transfer CALLTRANSFER

1.Press INT/TRAN button while in TALK mode.

2.The LCD display will show “INTERCOM

H1>H2” or “INTERCOM H2>H1” with a beep sound.

3.Press TALK or INT/TRAN button from the transferred handset to take the call. (The LCD display of the transferring hand-

NOTE:

If there is no response from the trans- ferred handset within 15 seconds, the LCD display of the transferring handset will show “RING BACK” with a beep sound. The transferring handset goes back to TALK mode.

Memory Feature

Your GH3210 is equipped with 10 memo- ries for programming your most frequently dialed telephone numbers. You can store up to 15 digits in each of the memory loca- tions 0 through 9 by following the steps outlined.

A record of the numbers to be speed- dialed may be kept on the memory index chart shown at the later part of this man- ual.

22