Southwing SH305, SH310, SH315 manual Introduction, Charging the Headset, Please Note

INTRODUCTION

Thank you for choosing a Bluetooth® product from SouthWing.

This user guide provides all the infor- mation you will need to use and care for your product.

All relevant information regarding your SouthWing product can be found on the support section of our website:

www.south-wing.com

1. CHARGING THE HEADSET

You will need to charge the battery of your Headset. To do so, follow these steps:

1.Plug the power supply into a power point

2.Plug the connector of the power supply into the USB Charging Socket [1]. The Indicator Light [2] will turn green to indicate the Headset battery is charging

3.Once the Indicator Light [2] turns off, the Headset is fully charged and can be removed from the power supply

Please Note:

·The Headset will not function while charging.

·If the Indicator Light [2] remains off when charging, the battery is already fully charged

and does not require further charging.

·To maximise battery life, do not charge the Headset for extended periods of time.

·Full battery capacity will be achieved after two or three full charge/discharge cycles.

·When your battery is flat, it takes up to four hours to completely charge your headset.

2. PAIRING THE HEADSET

Auto-pairing

For added convenience, your headset has an auto-pairing function so that when you turn the headset on for the first time, it is already in pairing mode (you will also hear a series of high tones). Then, follow these steps:

1.Put the mobile phone into pairing mode (see the instructions which came with your phone). Ensure that the mobile phone is no more than 1 metre away from the headset

2.Enter the PIN number: 1111.

If pairing is successful, the Indicator Light [2] will begin flashing every 3 se- conds.

Normal pairing

You will need to follow the steps below if you want to pair your Headset with another mobile phone.

You will be able to pair your Headset with up to 3 devices.

1.Ensure the Headset is off

2.Press and hold the On/Off Button [3] for about 5 seconds until the Indicator Light [2] flashes twice every second (you will also hear a series of high tones)

Then complete normal pairing process by following point 1 and 2 of the auto- pairing section above.

3.WEARING AND CARRYING

THE HEADSET

You can wear your Headset on either ear and carry it in different ways using the rotating Multi-function Arm [8].

® Bluetooth is a registered trademark owned by Bluetooth SIG, Inc. U.S.A. and licensed to SouthWing.

3