THROUGH-THE-WALL Installation, Back of Unit | WhisperKool 5000

THROUGH-THE-WALL INSTALLATION

Installing the System

Slide the unit from the outside wall into your wine cellar with the outer flange flush to the wall. Secure the flange to the wall through the pre-drilled holes. The screws should penetrate the studs as well as the upper and lower sup- ports to provide adequate support for the WhisperKOOL system (see illustration). Seal all cracks and gaps around the WhisperKOOL Extreme unit with an air-tight sealant or caulking to prevent air leakage.

Note: If you use decorative moulding, it should be attached to the walls and never to the cooling unit itself.

The moulding itself should be removable incase the unit needs servicing

2x4 Upper Support

Mounting Flange

Rear Power

Back of Unit

Drain Port

Wall Stud

2x4 Lower Support

Page 20

EXti 110111

Image 22

WhisperKool 5000 owner manual THROUGH-THE-WALL Installation, Installing the System, Back of Unit

Contents

Extreme 5000 Page Table of Contents Quick Reference Guide Front / Side View Fully Ducted Front / Side View 8000 / 8000 Rear / Side View Compressor Access Panel Standard Controller Layout Model Unit SpecificationsFAN Speed Reference Low Med High Introduction Receiving & Inspecting the Unit Review the Packing Slip to Verify ContentsCheck the Box for the following contents 5000 Receiving and Inspecting the Unit Quick Start Guide Insulation Preparing the Wine CellarVapor Barrier Unobstructed Airflow Mounting the UnitDoor and Door Seal Ventilation Air Intake Cellar Wall Ambient Temperature FactorUsing any other ducting system will void the warranty Exhaust Fan Electrical Needs PRE-INSTALLATIONElectrical Inlets Preparing the Installation Location Minimum Tools Needed Single Piece Mounting Bracket Preparing the System for InstallationMounting Bracket Installation Applying Insulation Tape 8000 Mounting Flanges Flush Installation Exterior Grille InstallationNon-Flush Installation Optional Exterior Grille 8000 Installing the System THROUGH-THE-WALL InstallationBack of Unit General Duct Recommendations Ducting OverviewUse of Ductwork Location of Supply and Return Grilles Three-Quarter Duct Configuration Wine Cellar Ducting ConfigurationsHalf Duct Configuration Wine Cellar Adjacent Room Fully Ducted Attic Mounted System Installing the Duct Plenums Remote Controller Installation Mounting Bracket Condensation Drain Line Tube Failure to install the drain line voids the warrantyDrain Line Drain Line Liquid Measuring Thermostat System Liquid Measuring Thermostat SystemSelf-Calibrating Probe To Use the thermostat 59/59 60/61 Multi FAN Speed Control57/57 System Operation Up and Down Button/Symbol Normal FunctionsStandard Controller Functions Arrows Alarm Anti-FrostPage Standard Remote Controller Functions Button Normal Functions Check Evaporator Probe connection at green terminal block on Cpsm Mode Remote Wire Schematic  Maintenance Schedule Unit does not run/power up Possible Cause Solution Cellar Temperature is to Warm Possible Cause Solution Possible Cause Solution Unit leaks water Possible Cause SolutionUnit runs but does not cool Possible Cause Solution Compressor short cycles Possible Cause Solution Technical Assistance Accessories for Cooling UnitsContact WhisperKOOL Customer Service Condensate Pump Kit Installation Terms and Conditions WhisperKOOL Cooling System Product Installation Requirements Model Serial NumberA Installed by Date Sales and USE TAXPage Page WhisperKOOL