WhisperKool 5000 owner manual 8000, Mounting Flanges, Preparing The System For Installation

PREPARING THE SYSTEM FOR INSTALLATION

8000 / 8000

Mounting Flanges

Your system utilizes mounting flanges (4) to frame the installation location and secure the unit to the wall.

Applying Insulation Tape

Locate the (4) precut pieces of black foam tape included with the system, two larger pieces and two smaller pieces. To apply, simply peel back the white-paper adhesive covering and place on the mounting flange. The small pieces are applied to the top and bottom while the larger pieces are for the sides. This foam creates a tight seal between the flange and the wall.

Mounting Flange Installation Select your desired flange mounting location (see diagram below), this location deter-

mines the depth of the installation. For example, position #1 keeps most of the system out of the

cellar while position #3 makes the back of the system near flush on the exterior wall. Use the (8) supplied 1/2” self tap- ping screws to fasten the flanges to the unit. It is imperative to not use self tapping screws longer than 1/2” in length.

If you are installing through an exterior wall, please review page 19 for

specific instructions on exterior grill installation.

Wine Cellar

Mounting Flange

Exhaust Area

5” inch thick wall (wall thickness may vary)

11.5-12.5” inches In Cellar

15.5-16.5” inches In Cellar

19.5-20.5” inches In Cellar

#1

#2

#3

Page 17