Set 1. Press the “Set” button once and it will display the Set Point. After approximately 5 sec- onds, the display will return to normal operation and display the Bottle Probe tempera- ture.
2.Press the “Set” button once and it will display the Set Point. Press the up and down ar- rows to change the set point. Press the Set button again and the numbers will blink, confirming the change in Set Point.
3.Press and hold the “Set” button during the display of the Hi/Low “Temperature Data His- tory” (hold button unit “rst” blinks on display), and it will erase the past recorded data file and start recording, from the current time and temperature.
4.Press the “Set” and the “Down Arrow” buttons simultaneously, for
Alarm The Alarm symbol is shown when the system encounters an issue that needs attention, the displayed alarm codes are explained below.
|
| Alarm Codes | |
|
|
|
|
Message | Cause |
| Solution |
“P1” | Bottle Probe is Unplugged |
| Attach Bottle Probe to Unit |
|
|
| |
Faulty Bottle Probe Connection |
| 1. Check Bottle Probe attachment at circular connector | |
|
| ||
|
|
| 2. Check Bottle Probe connection at green terminal block on |
|
|
| back of controller |
| Defective Bottle Probe |
| Replace the Bottle Probe |
“P2” | Faulty Evaporator Probe |
| Check Evaporator Probe connection at green terminal block on |
| Connection |
| back of controller |
| Defective Evaporator Probe |
| Replace the Evaporator Probe |
“HA” | Defective Bottle Probe |
| Replace the Bottle Probe |
“LA” | The Bottle Probe is sensing a |
| Allow the room to warm up which will increase the temperature |
| temperature of 4° below the set |
| of the wine |
| point |
|
|
| Defective Bottle Probe |
| Replace the Bottle Probe |
“POF” | The keypad is locked |
| Hold “Up” and “Down” buttons for 3 to 5 seconds to disable, |
|
|
| “PON” should appear |
Page 36 | EXti 110111 |
