WhisperKool 5000 owner manual Anti-Frost, Alarm

SET 1. Press the “Set” button once and it will display the Set Point. After approximately 5 sec- onds, the display will return to normal operation and display the Bottle Probe tempera- ture.

2.Standard Controller - Press and hold the “Set” button for 3-5 seconds until the set point is displayed and the °F symbol starts blinking. Next press the “UP or Down” arrows to change the Set Point. Next press the “Set” button once and the Set Point numbers and the °F on the display will blink to confirm the new Set Point setting.

3.Press and hold the “Set” button during the display of the Hi/Low “Temperature Data His- tory” (hold button unit “rst” blinks on display), and it will erase the past recorded data file and start recording, from the current time and temperature.

4.Press the “Set” and the “Down Arrow” buttons simultaneously, for 10-15 seconds, and you will access the “Customer Preference Selection Mode” (CPSM). The CPSM allows the customer to “Fine Tune” the Control Operating System to their applicable choice.

Anti-Frost		The Anti-Frost Cycle is automatically activated when the evaporator temp has reached a low
		temp of 26° and has sustained that temp for a period of five minutes. During this cycle the
		compressor and condenser fans will turn off and the evaporator fans will continue to run.
		Once the temperature of the evaporator gets back up to 40° the cycle will deactivate and
		the system will revert back to normal operating conditions.
		At the beginning of the cycle the	symbol will be illuminated and the	symbol is
		illuminated during the anti-frost cycle.
	Alarm	The Alarm symbol is shown when the system encounters an issue that needs attention, the
		displayed alarm codes are explained below.

		Alarm Codes
Message	Cause	Solution
“P1”	Bottle Probe is Unplugged	Attach Bottle Probe to Unit
	Faulty Bottle Probe Connection	1. Check Bottle Probe attachment at circular connector
		2. Check Bottle Probe connection at green terminal block on
		back of controller
	Defective Bottle Probe	Replace the Bottle Probe
“P2”	Faulty Evaporator Probe	Check Evaporator Probe connection at green terminal block on back of
	Connection	controller
	Defective Evaporator Probe	Replace the Evaporator Probe
“HA”	Defective Bottle Probe	Replace the Bottle Probe
	The Bottle Probe is sensing a	Allow the room to warm up which will increase the temperature of the
“LA”	temperature of 4° below the set	wine
	point
	Defective Bottle Probe	Replace the Bottle Probe
“POF”	The keypad is locked	Hold “Up” and “Down” buttons for 3 to 5 seconds to disable, “PON”
		should appear

Page 32 EXti 110111