Hardware Setup

SY-7IZB+

Step 16. Power-On by Keyboard Jumper (JP10)

You can choose to enable the Power-On by Keyboard or Mouse

function by shorting pin 1-2 on jumper JP1, otherwise, short pin 2-3

to disable this function.

Support Power-

OnEnableDisable by Keyboard

JP10 Setting

Enable

Power-On by

Keyboard 1 2 3 function

(short pin 1-2)

Disable Power-

 

On by

1 2 3

Keyboard

function

 

(short pin 2-3)

 

Note: When using the Power-On by Keyboard function, please make sure the ATX power supply can take at least 720mA load on the 5V Standby lead (5VSB) to meet the standard ATX specification.

Step 17. Power On

You have now completed the hardware installation of your

Motherboard successfully.

1.Turn the power on

2.To enter the BIOS Setup Utility, press the <DEL> key while the system is performing the diagnostic checks,

Note: If you have failed to enter the BIOS, wait until the boot

up sequence is completed. Then push the RESET button and

press <DEL> key again at the beginning of boot-up, during

diagnostic checks.

23

Page 26
Image 26
SOYO SY-7IZB+ manual Power-On by Keyboard Jumper JP10, Power On, Support Power, JP10 Setting