SOYO SY-7IZB+ manual Select Standard Cmos Setup, Select Soyo Combo Setup

Hardware Setup SY-7IZB+

2. Select [STANDARD CMOS SETUP]

Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to “Auto” .

3. Select [SOYO COMBO SETUP]

Move the cursor to the [CPU Frequency] field to set the CPU frequency, as shown in the following display.

Available [CPU Frequency] settings on your SY-7IZB+ Motherboard are detailed in the following table. You are then required to fill in the next two consecutive fields: (1) the CPU Host/PCI Clock, and (2) the CPU Frequency.

CPU Frequency

300MHz (66 x 4.5)

333MHz (66 x 5.0)

366MHz (66 x 5.5)

400MHz (66 x 6.0)

433MHz (66 x 6.5)

466MHz (66 x 7.0)

500MHz (66 x 7.5)

Select the working frequency of your Celeron TM processor among these preset values.

Note: Mark the checkbox that corresponds to the working frequency of your Celeron TM processor in case the CMOS configuration should be lost.

Note: if you use Bus Frequencies of 75 MHz, make sure that

your PCI cards can cope with the higher PCI clock.

25