FIGURE 5.
MAGNET PLACEMENT

placement of the magnet is correct. (See figure 4). For the best signal

reception, adjust angle of the transmit-

ter so that it is verti-

cal. It is not neces-

sary, or desirable to

aim the transmitter at the computer.

Wheel magnets have been provided for both traditional round spokes and bladed (flat) aerody- namic spokes.

For wheels with round spokes: Attach the magnet to a spoke across from the transmitter with the magnet screw. The clearance between the

6

magnet and the transmitter should be approximately 1/32"-1/16" (1- 2mm). Tighten the magnet and trans- mitter. Do not over-tighten the magnet screw. (See figure 5).

For wheels with bladed spokes;

Use some isopropyl (rubbing) alcohol or a mild detergent to thoroughly clean the spoke that you plan to attach the magnet to. Remove the backing from the adhesive tape and firmly press the magnet onto spoke. The tape uses a special pressure sen- sitive adhesive. To ensure a strong bond, please wait at least 12 hours for the adhesive to cure before riding your bicycle.

Your SpeedZone Pro comes pre-con- figured with a strap to fit standard

FIGURE 6. STRAP INSTALLATION

road and mountain bike handlebars. Attach the mount to the handlebar using the Philips head screw provid- ed. Tighten so that the bracket cannot rotate on the handlebar. There are several sizing shims provided to fit different diameter bars. If you are using the new 31.8mm diameter bars, you will need to purchase the 31.8mm Handlebar Mount Kit

(Specialized P/N 4812-3100) from your Specialized dealer. To install the 31.8mm diameter strap onto your SpeedZone Pro, remove the two Philips head screws from the bottom of the computer and push out the retaining pin with a small screwdriver or a straightened paperclip. (See fig- ure 6) Use caution not to lose the pin once you have removed it. Install the other mounting strap and reinsert the pin and screws. To test for proper installation of the magnet, transmitter and computer, activate the computer by pushing the ‘MODE’ (right side) button. Pick up the front of the bicycle and spin the front wheel. The "wheel option" indicator will flash. If it does not flash, check the sensor and mag- net alignment. Realign as necessary

7

Page 4
Image 4
Specialized CR2032 manual Strap Installation