•Using the 13/14mm Wrench, tighten the three bolts, and the fourth bolt which is
•There will be three electrical wire connectors at the top opening of the console mast, two 2 pin connectors for hand pulse sensors (36), one 10 pin connector for main wire harness (31) and one connector for resistance switch (124). Connect these to the mating connectors on the back of the electronic Console (30). The connectors are keyed, you cannot plug them in the wrong way so do not force them. The two, 2 pin connectors can be plugged into either connector on the back of the console.
•Storing the excess wire back into the Console Mast, carefully install the Console onto the mounting plate of Console Mast and secure using the four M5 x 10m/m Phillips Head Screws. Make sure the wires do not get pinched between the console and mounting plate.
STEP 2: HANDLE BAR ASSEMBLY
•Install the two 17m/m Wave Washers (83) onto the Left and Right side of the Handle Bar axle.
•Slide the Left (10) and Right (11) Handle Bars onto the appropriate side of the axle. The handlebars have a small sticker on them indicating L (left) and R (right).
•Put the two 5/16" x 23mm Flat Washers onto the two 5/16" x 15m/m Hex Head Bolts and install, and tighten, in the threaded holes in the ends of the axle.
14 | XE195 / XE295 Elliptical |
|
