Sprint Nextel SP-514 owner manual Entering a Pause

43-5514.fm Page 18 Wednesday, August 18, 1999 12:47 PM

Telephone Operation

1Press PROG/MEM.

2 Enter the number you want to store. (To store the last number you dialed, sim- ply press REDIAL.)

If you enter a wrong digit, press PHONE twice to exit the proce- dure. Then start over at Step 1.

3Press PROG/MEM then press one of the number buttons (0–9). The SP-514 beeps three times.

Note: If you receive a call while you are storing information in memory, press PHONE to answer the call. A tone sounds. After the call, begin again at Step 1.

Amemory index sticker is supplied with your SP-514. We recom- mend you write each stored number next to its number key loca- tion (MEM 1 for number 1, MEM 2 for 2, and so on). (Use a pencil in case you change the stored number.) Peel the backing from the sticker and attach it to the handset or the base.

To replace a stored number, simply store a new one in its place.

Entering a Pause

In some telephone systems, you must dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. You can store the access code with the phone number. However, you should also store a pause after the access code to allow the outside line time to connect. To do so, hold down the number immediately preceding the pause until you hear a second beep. (For example, if 9 is your access code, hold down 9 until you hear a second beep.) This enters a 1.5-second pause.

18