Stanley Black & Decker DS06 manual Replacing The Chain Breaker Punch, Spinning Rivets

MAINTENANCE & ADJUSTMENTS

REPLACING THE CHAIN BREAKER

PUNCH

If the chain breaker punch (part number 22801) becomes worn or damaged, use the following prcedures for replace- ment.

1.Remove the punch by loosening the set screw (Figure 15).

Figure 15. Removing the Punch

2.Insert a new punch into the holder and push it up until it is fully seated (Figure 16). Secure the punch to the chain breaker holder by fully tightening the set screw.

Figure 16. Replacing the Punch

Figure 17. Rivet Spinner Mounting

2.Lay the chain across the plastic chain supports and then rotate the supports so the rivet head is centered between the take-up handle pocket and the spinner anvil (Figure 18).

Figure 18. Positioning the Chain

3.Turn the take-up handle until the chain is tight against the spinner anvil (Figure 19).

Take-up

Rivet SpinnerHandle

Crank

SPINNING RIVETS

The following procedures explain how to spin rivets using Stanley’s bench-mounted rivet spinner (part number 20857) to assembly the chain.

1.Mount the rivet spinner fl ush with the side or front of a fl at, clean work surface (Figure 17).

Figure 19. Securing the Chain

16