Stanley Black & Decker DS06 manual Nose Sprocket Disassembly Assembly, Spinner Oiling Chambers

MAINTENANCE & ADJUSTMENTS

4.turn the rivet spinner crank a few times to center the rivet hub in the spinner anvil (Figure 20).

Take-up

Rivet SpinnerHandle

Crank

Figure 20. Centering the Rivet Hub

5. Apply a few drops of oil to the rivet hub (Figure 21).

Figure 23. Spinner Oiling Chambers

NOTE:

the rivet spinner is equipped with oiling chambers and should be maintained periodically with a light-weight oil (Figure 23).

NOSE SPROCKET DISASSEMBLY

AND ASSEMBLY

Figure 21. Applying the Oil

6.Turn the spinner crank while slowly running the take-up handle inward (approximately one full revolution) until the rivet head is formed (Figure 22).

Note:

The take-up handle provides pressure while the spin- ner anvil forms the rivet head.

Figure 22. Forming a Rivet Head

1.Using the bench mounted chain breaker (see acces- sories), line up the 1/4 inch hole in the side of the chain breaker anvil with the chain breaker punch. Punch out the six nose sprocket rivets. See Figure 24.

Figure 24. Punching Out Nose Sprocket

Rivets

2.Insert a straight blade screw driver to spread the bar nose rails just enough to remove the old nose sprocket. Use a rag or paper towel to clean the nose sprocket area. See Figure 25.

17