OPERATION
Set Position O4:
UNVALID POINT
RETURN TO PO1
Position O4 must be vertical from Position O1.
When the beads number has been modified:
ERROR !!!
SPACING > xx.x mm
The step is bigger than the maximum allowed step. Raise the number of beads.
ERROR !!!
SPACING < xx.x mm
The step is smaller than the minimal allowed step. Reduce the number of beads.
These 2 values can be modified in the parameters menu.
ERROR
BEADS NUMBER > 3
The number of beads must be superior at 3.
DIV ERROR
Show an inappropriate calculation not allow by the software.
RW30 USER MANUAL - 21
