3. The ribbon should pass between the print head and the print head shield
(see Figure 1-6).
I
Figure I-6. Pass the ribbon between the print head and print head shield
4. After you have installed the ribbon cartridge, install the roller unit.
5. Open the rear cover using the two pits on either side.
6. Gripping the lock levers on both sides of the roller unit, fit the mounting
brackets onto the shaft inside of the printer mechanism. You will need
to tilt the roller unit slightly backward.
7. Secure the roller unit firmly by lowering into position, as shown in -
Figure l-7.
8. Close the rear cover.
6