Star Micronics NX-2420 0 Copyright 1990 Star Micronics Co., Ltd.

Federal Communications Commission

Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio f 3 uency

energy and, if not installed and used in accordance with the instructions, may cause harmful inte etmce

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and at, the user is encouraged to try to correct the

interference by one or more of the following measures:

l Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

l Consult the dealer or an experienced radiofl technician for help.

Unauthorized modifications of this product by the user will void his authority to operate the equipment

unless expressly approved by the patty responsible for compliance.

For compliance with the Federal Noise Interference Standard, this equipment requires a shielded cable.

The above statement applies only IO prinkrs marketed in the USA.

Statement of

The Canadian Department of Communications

Radio Interference Regulations

This digitalapparatus does not exceed the Class B limits for radionoise emissions from digital apparatus

set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le present appareil numerique n’&nen pas de bruits radio&ctriques depassant les limites applicables

aux appareils numeriques de la classe B prescrites darts le Rtglement sur le brouillage radio&crrique

Cdicd par le minisbe des Communications du Canada.

The above statement applies only lo printers m&led in Canado.

Trademark Acknowledgements

NX-2420, XB-2410, NX-2410, SPC-8K, SF-lODQ, RH-1OZ: Star Micronics Co., Ltd.

IBM PC, PC-AT, PC-XT, Proprinter X24E, Proprinter X24, PC-DOS: International Business Ma-

chines Co .

% Microsoft ASIC, MS-DOS: Microsoft Corporation

LQ-860, LQ-850: Seiko Epson Corp.

NOTICE

STAR’s express permission is forbidden.

l The contents of this manual are subject to change without notice.

. All efforts have been made to ensure the accuracy of the contents of this manual at the time of

~;e~;e$wever, should any errors be detected, STAR would greatly appreciate being informed

. The above notwithstanding, STAR can assume no responsibility for any errors in this manual.