ENGLISH

6. Adjusting the Near-end Sensor

Use the following procedure to adjust the near-end sensor so it is compatible with the size of roll paper you are using.

1Open the printer cover.

2Determine the diameter of the roll paper you are using and find the required

setting in the table below.

3Insert the tip of a ballpoint pen or similar pointer object into the hole of the adjuster. While pressing the adjuster, slide it up or down to the setting that matches the roll paper you are using.

Make sure the tab indicated by the arrow in the illustration is inside one of the grooves.

Level 3

Level 2

Level 1

Important!

The wall mount model can only be used at level 3, and therefore must not be modified. Make the necessary adjustments to the standard model.

– 19 –

Page 22
Image 22
Star Micronics TSP800 user manual Adjusting the Near-end Sensor