Manuals
/
Brands
/
Computer Equipment
/
Printer
/
Star Micronics
/
Computer Equipment
/
Printer
Star Micronics
TSP828L Series
- page 14
1
14
50
50
Download
50 pages, 1.12 Mb
–
11
–
(6)
Peel off a label that is within 150 mm from
the end of the roll paper, and place the roll
paper in the direction shown.
(7)
Pull out the end of the backing paper to-
wards you.
(8)
Close the inner cover, and firmly press
both its ends.
Contents
Main
EC Council Directive 89/336/EEC of 3 May 1989
EC Council Directive 73/23/EEC and 93/68/EEC of 22 July 1993
Trademark acknowledgments
Notice
TABLE OF CONTENTS
1. Unpacking and Installation
1-1. Unpacking
2
2. Parts Identification and Nomenclature
Dual Interface Model
Parallel Interface Model
Choosing a place for the printer
WARNING
3. Setup
3-1. Connecting the Cable to the PC
3-2. Connecting the Cable to the Printer
Page
3-3. Installing the Printer Software
Page
3-5. Turning Power On
Page
Page
Page
Page
Page
Page
Page
Caution Symbol
WARNING
4. Thermal Roll Paper Specification
4-1. Thermal Label Roll Paper
20
Recommended label paper:
21
Recommended label paper specifications: Use roll paper that meets the conditions below.
Effective printing range: The printable range of label paper is shown below.
Page
23
(6) Effective printing range when using label paper with black mark specifications.
4-2. Thermal Roll Paper
5. Control Panel and Other Functions
5-1. Control Panel
1) Automatically recoverable errors
5-2. Errors
5-3. Self-Printing
5-4. Adjusting the Sensors
Page
Page
Page
6. Preventing and Clearing Paper Jams
6-1. Preventing Paper Jams
6-2. Removing Paper Jam
7. Periodic Cleaning
7-1. Cleaning the Thermal Head and Ground Hardware
7-2. Cleaning the Printer Cover, Paper Guide, and Peeler Sensor
8. Specifications
8-1. General Specifications
8-2. Interface
8-3. Electrical Characteristics
8-4. Environmental Requirements
8-5. Reliability
9. Dip Switch Setting
9-1. Parallel Interface Type
9-2. Dual Interface Type
Page
Page
DIP-SW 3
Parallel interface connector (printer side)
10. Parallel Interface
11. Dual Interface
11-1. RS-232 Interface
11-1-2. Connectors and Signal Names RS-232
45
11-1-3. Cable Connections The followings are a recommended interface cable connections.
Note:Use shielded wire less than 3 m in length.
11-2. USB Interface
12. Memory Switch Settings