– 39 –
DIP-SW 2
Switch Function ON OFF
2-1
2-2 Always ON Should be set to on
2-3
2-4
The factory settings of DIP switch are all on.
9-2-2. RS-232 Interface Type
ON ON
OFF OFF
DIP-SW 1
Switch Function ON OFF
1-1 Command emulation See table below
1-2
1-3
Should not be changed (Should be set to on)
1-4 Sensor adjustment Valid Invalid
1-5
Should not be changed (Should be set to on)
1-6 Handshaking conditions Offline or receive Receive buffer full
(conditions for BUSY) buffer full
1-7 Selection of detector for thermal Transmission type Reflection type detector
label paper (*1) detector
1-8 Selection of roll paper (*2) Thermal label roll paper Thermal roll paper
The factory settings of DIP switch are all on.
Emulation
Switch 1-1 Switch 1-2 Emulation
ON ON STAR Line Mode
OFF ON STAR Page Mode
ON OFF (reserved)
OFF ON (reserved)
Notes:
*1) Only a reflection type detector may be used on thermal roll paper.
*2) Two modes are available for the thermal label roll paper: a peeler mode and a tear bar
mode (without using peeler). These modes are recognized automatically.
No. 1
DIP-SW1
2 3 4 5 6 7 8
No. 1
DIP-SW2
2 3 4