Star Micronics TSP828L Series - page 43

– 40 –
DIP-SW 2
Switch Function ON OFF
2-1
2-2 Always ON Should be set to on
2-3
2-4
■DIP Switch 3
The factory settings of DIP switch are all on.
The following is the procedure for changing the settings on DIP switch No. 3.
1. Turn off the printer and all components connected to it.
2. Remove the 2 screws.
3. Remove the dual interface board unit.
4. Change the setting of the DIP switches.
5. Replace the dual interface board unit.
6. Then secure it with the screws.
7. Turn on the printer and all components connected to it.
DIP switch 3
DIP-SW3
The factory settings of DIP switch are all on, except for switches 1, 2, 7 and 8.