Star Micronics XB24-250 II Using the EDS Mode, About EDS Mode settings, Entering the EDS Mode

24

Chapter 3: Using the EDS Mode

The letters “EDS” stand for “Electronic DIP Switches.” Just like the small DIP switches that are used by many computers, printers, and other devices, the EDS mode lets you configure the printer so that it matches your system and software needs. This chapter describes how to enter the printer’s EDS Mode and provides details about available settings and how to change them.

All switch settings are ON when the printer is shipped from the factory.

About EDS Mode settings

EDS Mode settings are grouped among six “banks” (representing banks of switches) that are identified by the letters A through F. Each bank contains a number of “switches” numbered 1 through 6 that you can turn on and off to configure the printer.

Entering the EDS Mode

❏Make sure that paper is loaded in the printer.

❏Turn off the printer.

❏While holding down the control panel’s ON LINE, LINE FEED, and FORM FEED buttons, turn the printer back on.

This causes the following message to be printed, which indicates the printer is in the EDS Mode.