Star Micronics XB24-250 II user manual Using the EDS Mode, BANK D Switches 1, 2, 3, 4 Page Length

30Using the EDS Mode

BANK D

Switches 1, 2, 3, 4: Page Length

Turn these switches on or off to form the pattern that matches the Page Length setting you want to use.

Page Length	SW1	SW2	SW3	SW4
11”/Letter	ON	ON	ON	ON
8”	OFF	ON	ON	ON
11.7”/A4	ON	OFF	ON	ON
12”	OFF	OFF	ON	ON
8.5”/Letter	ON	ON	OFF	ON
14”/Legal	OFF	ON	OFF	ON
10.5”/Executive	ON	OFF	OFF	ON
7.25”/Executive	OFF	OFF	OFF	ON
3.5”	ON	ON	ON	OFF
5.5”	OFF	ON	ON	OFF

Switch 5: CR Centering Position

If you set this switch OFF, the carriage moves to the center each time to feed paper near the perforation. This way, you can get better quality of printing around the perforations. It is recommended to match the page length setting to your fanfold paper, otherwise, this function does not work properly at the perforations.

If you leave this switch ON, the carriage does not move when feeding paper.

Switch 6 : Not used

BANK E

Switches 1, 2, 3, 4, 5: Code Page/International Character Set

If your EDS settings specify IBM emulation (Bank A, Switch 1 OFF) with either character table (Bank A, Switch 2), or Standard emulation (Bank A, Switch 1 ON) with the graphics character table (Bank A, Switch 2 ON), use the Bank E switches to select the default character code page you want to use.