Star Micronics XB24-250 II user manual Troubleshooting, DOT ADJUSTMENT SETTING Normal-density

Repeat the above steps for each printing mode, if necessary.

Press SET/EJECT/PARK to change to another printing mode.

❏

❏

❏ After making changes to adjustments in all the printing modes you want, press ON LINE to exit the Dot Adjustment Mode and register your adjustments.

Note that the printer will feed the paper forward and back each time during this operation so you can view the printout.

❏ If the two lines do not align properly, use FONT to move the middle line to the left or PITCH to move it to the right.

The above step performs alignment for Normal-density mode only. You must make separate adjustments for the HS-DRAFT, CRT graphics mode I, DRAFT Graphics, DRAFT Graphics Speed Down, Double-density, CRT graphics mode II, CRT graphics mode2 SD, Triple-density, Quadruple- density, LQ Graphics, LQ Graphics Speed Down modes as well.

48Troubleshooting

❏While holding down the control panel’s FORM FEED and ON LINE buttons, turn the printer back on to enter the Dot Adjustment Mode.

The printer will print something like the following.

***DOT ADJUSTMENT SETTING ***

Normal-density 0: