ASSEMBLY AND SETUP
UNPACKING
NOTE: Do not remove the base from the shipping carton at this time.
Remove the top cover from the shipping carton. Remove all parts and shipping supports (except the base) from the carton, and verify that the following parts are included in your shipment:
Description | Qty | Description | Qty |
Base | 1 | Bolt, Hex Head, __________ | 8 |
Display | 1 | Screw, Phillips Head, ___________ | 8 |
Upper Body Arms | 2 | Flat Washer, ___________ | 4 |
End Caps | 2 | Lock Washer, ___________ | 8 |
Bolt, Allen Head, __________ | 4 |
|
|
TOOLS REQUIRED
Your STAR TRAC
n Metric Hex Key Wrenches | n | Channel Lock Pliers | |
n | Metric | n | Vice Grip Pliers |
n Metric Ratchet Socket Wrench Set | n | Rubber Mallet | |
n | Torque Wrench | n | Phillips Head Screwdriver |
Your STAR TRAC
ASSEMBLY
1. Unpack and Position the Base
CAUTION: The rear end of the base is very heavy. Two persons are needed to lift this end when moving the base.
Cut the long edge of the shipping carton base at both ends. Fold the flap down to make a ramp.
With the aid of a helper, lift the rear end of the base, and roll the base off of the shipping carton platform. Place the base on the floor in the location where the unit will be used. Be sure the chosen location is level.
Step 1
2. Install the Display
NOTE: You will need someone to assist you to install the display. Have the person who is assisting you hold the display while you route the display cables and connect the neck.
Have your helper hold the display close the neck on the base. Plug the display power and I/O cables from the base into the mating display connectors.
Once display power and I/O cables are connected, route the coaxial cable up the full length of the display neck before seating the display unit on the base.
NOTE: The round coaxial cable is not used.
Step 2a
STAR TRAC | 11 |
