Star Trac S-TBTX manual Install the Upper Body Arms

Gently push the display cables down into the neck, and slide the display into the base. Be sure the display is fully seated. Secure the display to the base with four ___________ bolts and _________

flat washers. Use two screws in the front side of the neck, and two in the rear side. Tighten the screws securely.

Step 2b

3. Install the Upper Body Arms

NOTE: Take care not to install the upper body arms backwards. Be sure the arms are positioned as shown when installed.

Place on upper body arm on the right-side hub. Be sure the pin in the arm bracket engages the unthreaded hole on the hub. Secure the upper body arm to the hub with four _________ bolts and

_________ lock washers. Tighten the bolts securely.

Repeat for the left-side upper body arm.

Step 3

4. Install the End Caps

NOTE: Be sure the holes in each end cap face the rear of the unit.

Separate the halves of the right -side end cap. Place the end cap halve around the hub. Use a piece of tape to temporarily hold the end cap halves together.

Secure the end cap halves together with four _________ Phillips head

screws. Tighten the screws firmly.

Repeat for the left-side end cap.

Step 4

5. Final Assembly

Be sure all bolt and screws are tightened securely.

If needed, use the leveling adjusters at the rear of the base to level the unit. Loosen the lock nuts on the adjusters. Rotate the adjusters until the unit is stabilized, then retighten the lock nuts.

You have now completed assembly of your STAR TRAC S-TBTx

TOTAL BODY TRAINER.

12	STAR TRAC S-TBTXTOTAL BODY TRAINER OWNER’S MANUAL
	Step 5