Sterling STT 300 STT 3.5.3. Entering hopper values, Start-up, Hopper entry X Target

STT 300

3.5.3. Entering hopper values

Select ”Hopper”.

Acknowledge with the ENTER-key.

or

Press the ”F4”-key.

Hopper entry X Target

(X = number of the drying hopper)

Enter the drying temperature for hopper flap X (when operating with supplementary heating).

Acknowledge with the ENTER-key.

Hopper entry X Act.

(X = number of the drying hopper)

The current temperature at the feed opening of hopper flap X will be displayed.

&

F

If there is a cable break “+0 °C” (32°F) is displayed.

The lowest drying temperature setting of the hopper flap must be the same as or higher than the drying temperature.

Press the “â” key.

SM2-615

Start-up 3-11