STEP 2. ELECTRICAL HOOK-UP
Electrical Connection Box (behind end plate)
Socket
Cap 
Screws
Electrical
Knockout
(optional)
Figure 6: Electrical connection box
Caution
Professional techniques need to be adhered to when making any electrical connection. A qualified electrician should perform these procedures.
Be sure to follow all standard safety procedures for installing electrical devices.
Do not disassemble or alter the configuration of the motor or the unit's electrical connections. This may cause injury to you or damage to the product.
The electrical connection should be made only to the type of power source indicated on the marking label.
The motor requires standard 120V 60 Hz input (unless an alternate voltage has been specified). All connections are made to the electrical box on the side of the Luxus unit (audience left).
In addition to the standard
General suggestions for wiring:
Soldering is recommended.
The use of wire nuts is acceptable.
On models not provided with armored whip, a romex connector should be installed in the appropriate electrical KO (Knock Out).
To open the electrical box, remove the two socket cap screws that attach the end plate to the unit’s case.
Refer to Figure 6 for an illustration of the electrical connection box on the side of the screen unit.
The standard electrical hook up is through the large black electrical grommet located on the back side of the case adjacent to the end plate.
An optional electrical knockout has been provided should the particular installation require that the electrical connection be made through the side end plate.
8 | Stewart Filmscreen Corporation |
