INSTALLATION INSTRUCTIONS
INSTALLATION
9.LOGIC E-BOX arrangEMENT OF fuel bed components
ADVICE ON HANDLING AND DISPOSAL OF FIRE CERAMICS
The fuel effect and side panels in this fire are made from Refractory Ceramic Fibre (RCF), a material which is commonly used for this application.
Preventive clothing is not required when handling these articles, but we recommend you follow normal hygiene rules of not smoking, eating or drinking in the work area, and always wash your hands before eating or drinking.
To ensure that the release of RCF fibres is kept to a minimum during installation and servicing, a HEPA filtered vacuum is recommended to remove any dust accumulated in and around the fire before and after working on it. When servicing the fire it is recommended that the replaced items are not broken up, but are sealed within heavy duty polythene bags and labelled as RCF waste.
RCF waste is classed as stable, nonreactive hazardous waste, and may be disposed of at a licensed landfill site.
Excessive exposure to these materials may cause temporary irritation to eyes, skin and respiratory tract; wash hands thoroughly after handling the material.
NOTE:CERAMICPARTSAREFRAGILE.THESIDEANDREARPANELS ARE REVERSIBLE. ONE SIDE IS PLAIN, THE OTHER SIDE IS REEDED
ONLY USE THE CORRECT TYPE AND QUANTITY OF CERAMIC COMPONENTS. Always follow the fuel bed layout as stated in these instructions. NEVER change the layout from that shown here.
9.1Position the burner cover gasket on the burner skin ensuring the holes align with the ports. Take care as the front
19
A
AR1372
9.2Place the rear panel against the rear of the box resting on the shelf. Then slide one of the side panels into the box
ensuring it touches the rear panel. Then gently ease the front edge of the side panel behind the flange so it lies flat against the wall of the box. Repeat with the second side panel., Diagram 20.
20
AR1359 |
| AR1360 |
|
|
|
9.3Locate the top panel on top of the sides and rear by lifting it up and forward inside the box. Then sliding it backwards and down behind the side panels and resting on the rear panel, Diagram 21.
21
AR1361
Coal Layout
9.4Position the flame baffle centrally on the tray and ensure the stepped lower edge engages against the rear edge of the burner skin, Diagram 22.
22
AR1362
9.5Place the front coal centrally in the channel at the front of the tray. See diagram 7. The relationship between the front coal and the flame baffle is shown in diagram 23.
20
