W O L F GAS BBQ GRILL U S E & C A R E
LIGHTING T H E B B Q G R I L L
Open the hood.
Push in and turn the gas control knob counterclockwise to HIGH.
Keep your face as far away from the burners as possible.
Press and hold the ignition button that corresponds with the gas control knob until the burner lights.
Listen for a ”woosh” sound. If the burner does not light after approximately five seconds, turn the control knob to the OFF position. Wait five minutes until the gas clears.
Repeat the procedure or use the manual lighting procedure described on page 10.
If a burner is lit, flames will be visible through a series of vertical slots just above the control knob of the corresponding burner. Keep your face away from the front panel.
Upon successful lighting, repeat the process for the other burners you wish to light.
Dimensions in parentheses are in millimeters unless otherwise specified.
O P E N BURNERS
Wolf BBQ grill open burner models are equipped with
L I G H T I N G T H E O P E N B U R N E R S
Remove the open burner cover and any utensils on the grate.
Follow the same steps as for lighting the grill. Note that the open burners, front and rear, are lit by a single electrode. Turn on the gas to the desired burner, then press the ignition button. One ignition button lights both burners.
FLAME H E I G H T
The correct flame height is dependent on the size and material of the cookware being used, the food being cooked and the amount of liquid in the pan. Cookware that conducts heat slowly, such as glass or ceramic, should be used with a low or medium flame, unless you are cooking with a large volume of liquid. The flame height should not extend beyond the bottom of the pan.
9
