Convection Steam Oven Installation | 12 |
|
|
Install the Oven
WITHOUT TRIM
IMPORTANT NOTE: Before moving the oven, protect any finished flooring and cabinetry to avoid damage.
1)Move the convection steam oven into position near the installation opening. Remove and discard packing materials.
2)Carefully place the oven in the opening. Resting the oven on the cabinet base support, slide the unit into the opening until it is approximately 6" (152) from being fully installed. Guide the power cord through the opening of the adjacent cabinet or base support as the oven is slid into position. Verify the power cord is not trapped between the oven and cabinet wall.
3)Once the oven is fully positioned in the opening, open the oven door and locate the four mounting holes on the oven side trim. Refer to the illustration below. Use a 1/16" drill bit to drill pilot holes into the cabinet.
4)Using the mounting screws provided, secure the oven to the cabinet.
IMPORTANT NOTE: To avoid interference, a 90° door stop may be required for any appliance or cabinet door installed next to the convection steam oven.
Failure to install the mounting screws may cause the oven to tip forward during use.
OVEN MOUNTING HOLES |
Oven installation without trim.
