FRAMED PANEL I N S TA L L AT I O N
With a Phillips screwdriver, remove the handles from the freezer and refrigerator doors. Slide the panel into the frame on the door. With the panel in position, replace the handles. Be sure the panel is inserted completely into the channel for proper fit and alignment. Refer to illustration 11 on page 12.
Replace the trim molding by inserting the top, then the bottom into the handle channel. Release the middle and set the magnets.
R A I S E D PA N E L S
You may have to rout, recess or use optional extended handles with some door panel designs to allow for finger clearance. This is particularly true if your unit has raised panels greater than 1/4" (6) total thickness.
IMPORTANT NOTE: The weight of each panel cannot exceed 50 lbs (23 kg).
Check the location of offset when you’re using specific routing for the grip area only. Refer to the
Dimensions in parentheses are in millimeters unless otherwise specified.
M O D E L S 6 8 5 A N D 6 9 5 FRAMED KITS
PA RT I A L F R A M E D A C C E S S O RY K I T
If you choose not to use custom wood panels above or below the glasswell for the Model 685 or 695 framed application, a stainless steel insert panel will be provided with the partial framed accessory kit. This accessory kit (part #FRAMPAR), available through your
Detailed installation instructions are included with the partial framed accessory kit.
F R A M E D R E T RO F I T A C C E S S O RY K I T
With the framed retrofit accessory kit, existing Model 680 or 690 door panels can be used on a new Model 685 or 695 framed unit. This accessory kit (part #FRAMRET), available through your
Detailed installation instructions are included with the framed retrofit accessory kit.
PA N E L
D E S I G N
Additional panel design information can be found in the
13
