D E Pa N E L I N S Ta L L At I O N O P T I O N S

COMPLETING T H E I N S TA L L AT I O N

SIDE PANEL I N S TA L L AT I O N

If you’re installing a Built-In model with side panels, check with your installer or use one of the following Side Panel Installation Options.

Drill three holes equidistant in a vertical section of the aluminum frame, and install pan head screws. Do not drill through model and serial number plate. Anchor the side panel with decorative screws or finishing nails from a local hardware store. Do not use adhesives. Refer to illustration 16 below.

The dimensions given in the Side Panel Installation Options are for typical wood side panels. If a 1/4" (6) thick or less panel is used and inserted into the return channel extrusion, then a 241/4" (616) wide panel is necessary. In this application, the panel must be notched for the grille and other brackets or screws that are in the return channel. Toe kick cut-outs will be necessary for all side panel applications. Refer to illustration 17 below.

IMPORTANT NOTE: The use of side panels may change the width of your rough opening.

IMPORTANT NOTE: The overall height on the side panel will vary with the height of the grille being used. Make sure you know your finished height before cutting any panels.

S I D E PA N E L I N S TA L L AT I O N O P T I O N S

1/4" (6) THICK SIDE PANEL FITTED IN TO UNIT FRAME

DOOR	PAN HEAD SCREW		1/8" (3) THICK BATTENS

		SIDE OF SUB-ZERO UNIT
FRAME		1/4" (6) SIDE PANEL MATERIAL
		241/4" (616)
1/4" (6) THICK SIDE PANEL FITTED UP TO UNIT FRAME
DOOR	PAN HEAD SCREW			1/4" (6)
	1/8" (3) THICK BACK-UP			THICK BATTENS
		SIDE OF SUB-ZERO UNIT
FRAME		1/4" (6) SIDE PANEL MATERIAL
		24" (610)
3/8" (10) THICK SIDE PANEL FITTED UP TO UNIT FRAME
DOOR	PAN HEAD SCREW		1/8" (3) THICK BATTENS

		SIDE OF SUB-ZERO UNIT
FRAME		3/8" (10) SIDE PANEL MATERIAL
		24" (610)
1/2" (13) THICK SIDE PANEL FITTED UP TO UNIT FRAME
DOOR	PAN HEAD SCREW
	FRAME 1/8" (3) ROUT
		SIDE OF SUB-ZERO UNIT