Sun Microsystems 150 !

16 Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide •June 2002

2. Place the CD (label side up) into the tray.

Ensure that the CD is properly set into the recessedarea of the tray.

3. Push the tray to close it.

Youmay need to unmount the CD before manually ejecting it.

There are threeways to eject a CD:

■Press the eject button on the front of the CD-ROM drive.

■Use software commands to eject the CD. Refer to the peripherals handbook that

corresponds with your operating system.

■If the motorized eject mechanism does not operate, insert a thin, stiff wire(such

as a paper clip) into the hole next to the eject button.

If your CD-ROM drive cannot read a CD or DVD, the cause may be a dirty CD or

DVD. Follow these guidelines to clean a CD or DVD:

■Use a soft, clean, lint-free, dry cloth.

■Clean the unlabeled side of the CD or DVD.

■Wipethe CD radially from the center to the outside.

■Use professional cleaning kits.

Caution – Do not use solvents such as benzine, paint thinner,antistatic aerosol

spray,or abrasive cleaners to clean CDs.

Follow these guidelines when handling and storing CDs:

■Handle CDs only by their edges; avoid touching CD or DVD surfaces.

■Writeonly on the premarked label side of a CD or DVD. Use a soft felt-tip marker.

■Do not use CDs in high-dust environments.

■Keep CDs out of direct sunlight, extreme sources ofheat or cold, and away from

dust and moisture.

■Make sure CDs are at room temperaturebefore using them.

■Store CDs in storage boxes so that they remain clean and free of dust.