124 Sun StorEdge Network FC Switch-8 and Switch-16 Installation and Configuration Guide • October 2001
Adding a Sun StorEdge T3 Workgroup or
Enterprise Array
The following applies to when the Sun StorEdge T3 array is connected as a Fabric
device (an array to a switch TL_port and a host port to a switch F_port). If Sun
StorEdge TrafficManager is enabled, refer to “To Configure a Fabric-Connected
Device as a Sun StorEdge TrafficManager Device” on page 101. If Sun StorEdge
TrafficManager is not enabled, refer to “To Configure a Fabric Device” on page 91.
Adding a Sun StorEdge A3500FC Array
Use the boot -r command after installing RAID Manager 6.22.1 and the first Sun
StorEdge A3500FC array.
Youcan add additional Sun StorEdge A3500FC arrays without rebooting, but you
must run the /usr/lib/osa/bin/hot_add command.
Adding a FC-Tape Drive
See the following documentation for additional information:
■For the L180:
■L180 Operator’s Manual
■L180 Installation Manual
■L180 Information Manual
■L180 Assurance Guide
■For the L700
■L700 Operator’s Guide
■L700 Service Manual
■L700 Systems Assurance Manual
Removing Storage DevicesThis section contains the following topics:
■“Removing a Sun StorEdge A5200 Array” on page125
■“Removing a Sun StorEdge T3 Array Workgroupor Enterprise Configuration” on
page125
■“ToRemove a Sun StorEdge A3500FC Array” on page 125