Using your StickMaster stick blender continued
Using the processing bowl attachment with the slicing/shredding disc
1.Place the processing bowl on the
2.Fit the shredding/slicing disc with the spindle into the processing bowl.
3.Attach the lid onto the processing bowl and rotate the lid in a clockwise direction until it locks into position.
4.Insert the motor housing into the hole on the top of the processing bowl attachment until you hear a click. See Figure 5.
5.Plug the power cord into a
7.Select the optimal speed for the processing task by turning the speed control dial from 1 to 5 and then depressing the power button (I). Speed one on the speed control dial is the slowest and speed five is the fastest.
Note: All stick blenders are designed to operate only whilst the power buttons remain depressed.
8.For an extra boost of power during operation, the turbo speed button (II) may be depressed.
Note: The power button (I) should be released when selecting the turbo speed button (II).
9.To stop the stick blender, take your finger off the power button or turbo speed button.
10.To detach the processing bowl attachment, push the buttons at either side of the base of the motor housing until the two pieces separate. See Figure 6.
Figure 5 |
|
6.Remove the food pusher and place |
|
ingredients into the feed tube. Using the | Figure 6 |
food pusher guide food down the feed tube |
|
evenly, while operating the power button |
|
with the other hand. |
|
8
