A+ SERVER
Unit Identifier Button
In addition to the UID (Unit Identifier) button on the rear I/O panel, there is another UID button located on the control panel. When you push either UID button, both Rear UID and Front Panel UID Indicators will illuminate. Push either button again to turn off both indicators. These UID indicators provide easy identification of a system unit that may be in need of service.
UID Button
Pin Definitions
Pin# Definition
1Ground
2Ground
3Button In
4Ground
LAN1/2 (Ethernet Ports)
Two Gigabit Ethernet ports (designated LAN1 and LAN2) are located beside the VGA port. Additionally, there is a dedicated LAN for IPMI on top of the two rear USB ports. These Ethernet ports accept RJ45 type cables.
LAN Ports (LAN1/2)
Pin Definition
Pin# | Definition | Pin# | Definition |
1 | P2V5SB | 10 | SGND |
2 | TD0+ | 11 | Act LED |
3 | TD0- | 12 | P3V3SB |
4 | TD1+ | 13 | Link 100 LED |
|
|
| (Yellow, +3V3SB) |
5 | TD1- | 14 | Link 1000 LED |
|
|
| (Yellow, +3V3SB) |
6 | TD2+ | 15 | Ground |
7 | TD2- | 16 | Ground |
8 | TD3+ | 17 | Ground |
9 | TD3- | 18 | Ground |
|
| ||
| NC indicates no connection. | ||
Compact Flash Card PWR Connector
A Compact Flash Card Power Connector is located at JWF1. For the Compact Flash Card to work properly, you will need to enable with JCF1 and connect a Compact Flash Card power cable to JWF1 first.
