![](/images/new-backgrounds/1108698/10869851x1.webp)
SUPERSERVER
2-5 Checking the Motherboard Setup
After you install the
1.Accessing the inside of the 5013C-M8 (Figure 2-4)
First, release the retention screws that secure the unit to the rack. Grasp the two handles on either side and pull the unit straight out until it locks (you will hear a "click"). Next, depress the two buttons on the top of the chassis to release the top cover. There is a large rectangular recess in the middle front of the top cover to help you push the cover away from you until it stops. You can then lift the top cover from the chassis to gain full access to the inside of the server.
2.Check the CPU (processor)
You may have one processor already installed into the system board. Each processor should have its own heat sink attached. See Chapter 5 for instructions on processor installation.
3.Check the system memory
Your
4.Installing add-on cards
If desired, you can install an
5.Check all cable connections and airflow
Make sure all power and data cables are properly connected and not blocking the airflow. See Chapter 5 for details on cable connections. Also, check the air seals for damage. The air seals are located under the chassis fans and beneath the frame cross section that separates the drive bay area from the motherboard area of the chassis.
Note: Make sure that the air seals are properly installed.