5-18
SUPERSERVER 5013C-M8 User's Manual
Keylock Enable/Disable
The Keylock header is located at
J36. Close the jumper to enable the
Keylock function and leave the
jumper open (off) to disable it. The
default setting is open. See the
table on the right for jumper settings.
Jumper
Position
Closed
Open
Definition
Enabled
Disabled
Keylock
Enable/Disable
Jumper Settings
(J36)
VGA Enable/Disable
J33 allows you to enable or disable
the VGA port. The default position is
pins 1 and 2 jumped to enable VGA.
See the table on the right for jumper
settings.
Jumper
Position
Pins 1-2
Pins 2-3
Definition
Enabled
Disabled
VGA Enable/Disable
Jumper Settings
(J33)
SCSI Enable/Disable
The JPA3 jumper allows you to en-
able or disable the onboard SCSI.
The normal (default) position is with
pins 1 and 2 jumped to enable SCSI.
See the table on the right for jumper
settings.
Jumper
Position
Pins 1-2
Pins 2-3
Definition
Enabled
Disabled
SCSI
Enable/Disable
Jumper Settings
(JPA3)
Watch Dog Enable/Disable
JP8 enables the Watch Dog function,
a system monitor that takes action
when a software application freezes
the system. Jumping pins 1-2 will
have WD reboot the system if a pro-
gram freezes. Jumping pins 2-3 will
generate a non-maskable interrupt
for the program that has frozen. See
the table on the right for jumper set-
tings. Watch Dog must also be en-
abled in BIOS.
Jumper
Position
Pins 1-2
Pins 2-3
Open
Definition
WD to Reset
WD to NMI
Disabled
Watch Dog
Jumper Settings (JP8)
Note: when Watch Dog is enabled, the user
must write their own application software to
disable the Watch Dog Timer.