SUPERSERVER 6014L-T User's Manual

5-6 Installing Memory

Note: Check the Supermicro web site for recommended memory modules: http://

www.supermicro.com/support/resources/

CAUTION

Exercise extreme care when installing or removing DIMM modules to

prevent any possible damage.

DIMM Installation (See Figure 5-3)

1.Insert the desired number of DIMMs into the memory slots, starting with DIMM1A and DIMM1B. Pay attention to the notch along the bottom of the module to prevent inserting the module incorrectly. (See support information below.)

2.Gently press down on the memory module until it snaps into place. Repeat to install all DIMMs.

Memory Support

The X6DLP-EG2 supports up to 16 GB of registered ECC DDR2-400 type SDRAM. The memory scheme is interleaved so you must install two modules at a time. Note: Due to OS limitations, some operating systems may not support more than 4GB of memory.)

Figure 5-3. Installing DIMMs

To Install: Insert module vertically and press down until it snaps into place. Pay atten- tion to the bottom notch.

Notch

Release

Tab

DIMM2

Note: Notches

should align with their receptive points on the slot

Not

Relea

Tab

To Remove: Use

your thumbs to gently push each

release tab outward to free the DIMM

from the slot.

5-8

Page 44
Image 44
SUPER MICRO Computer 6014L-T user manual Installing Memory, Dimm Installation See Figure, Memory Support