SUPER MICRO Computer X7DCL-i PCI Configuration, Onboard Storage Oprom Configure, Option ROM Scan

X7DCL-3/X7DCL-i User's Manual

PCI Configuration

Access the submenu to make changes to the following settings for PCI devices.

Onboard GLAN-1/Onboard GLAN-2 (Gigabit- LAN) OPROM

Configure

Select Enabled to allow the system to boot from the GLAN-1 connection or the GLAN-2 connection. The options are Disabled and Enabled.

Onboard Storage OPROM Configure

Select Enabled to allow the system to boot from the onboard storage device. The options are Disabled and Enabled.

Reset Configuration Data

If set to Yes, this setting clears the Extended System Configuration Data- (ESCD) area. The options are Yes and No.

Slot1 PCI 33MHz, Slot2 PCI 33MHz, Slot3 PCI 33MHz, Slot4 PCI-Exp. x4, Slot5 PCI-Exp. x8, and Slot6 PCI-Exp. x8

Access the submenu for each of the settings above to make changes to the following:

Option ROM Scan

When enabled, this setting will initialize the device expansion ROM. The options are Enabled and Disabled.

Enable Master

This setting allows you to enable the selected device as the PCI bus master. The options are Enabled and Disabled.

Latency Timer

This setting allows you to set the clock rate for Bus Master. A high-priority, high- throughout device may benefit from a greater clock rate. The options are Default, 0020h, 0040h, 0060h, 0080h, 00A0h, 00C0h, and 00E0h. For Unix, Novell and

other Operating Systems, please select the option: other. If a drive fails after the installation of a new software, you might want to change this setting and

try again. A different OS requires a different Bus Master clock rate.

Large Disk Access Mode

This setting determines the size of hard drive disk to be accessed by the system. The options are DOS or Other (for Unix, Novelle NetWare and other operating systems).

4-10