Setting the backlight
Light is the backlight of the Suunto X6/X6M display. Light has three possible settings:
•Normal: The light goes on when you press Start for more than 2 seconds in any other mode than the Chrono mode. The light is on for 5 seconds after the last press of any button.
NOTE: If the backlight setting is normal and you press Start in Chrono mode, the Chrono is activated. If you want to use the light in the Chrono mode, you have to set the backlight to Night Use.
•Off: The light does not go on from any button or during an alarm.
•Night Use: The light goes on when you press any of the buttons and stays on for 5 seconds after the last press of a button.
NOTE: The backlight goes on when an alarm sounds in Normal and Night Use.
To change the light setting:
1.In the Function menu, scroll to General and press Suunto. The General menu is displayed.
2.Scroll to Light and press Suunto. The current light setting is activated.
3.Select the light setting with the arrow buttons and press Suunto. The light setting is set and you return to the Function menu.
Calibrating the air pressure sensor
The pressure sensor of the Suunto X6/X6M is accurately calibrated when the product leaves the factory. However, the calibration can slightly shift over time. You can adjust the calibration offset but you should only do it if you notice that the current air pressure shown on the bottom row in the Weather mode differs from a reference value of the barometric pressure measured with a certificated
21
